How To Burn A Candle Without A Jar?

If you are a candle freak like me, you know most of the candle comes with a jar, which is cool. But most of the time, you burn the jar while lighting up, which doesn’t look cool. So, it is better to buy a candle without a jar. There are various cool tower or pillar candles out there. Wondering How to Burn a Candle Without a Jar? Well, it isn’t as complicated as you think right now. You just need to follow the steps attentively. Dig into finding out the steps.

Key Takeaways

• You should trim the wick of the candle.
• You should let your candle burn for 3/4 hours on the first go.
• Always keep your candle container clean.
• Never let the candle burn overnight.

Here is how to burn a candle without a jar

Here some solutions for you:

Wick the candle

The first step is to trim your candle wick. You don’t want to do this too early, though, since you’re still burning the wax off. If you wait too long, you’ll end up having to buy another one. So, start trimming them about 2 weeks into the life of your candle. Trimming the wick is pretty easy. Just follow these steps:

1. Cut off the tip of the wick. This is where most of the wax will come out.
2. Hold the wick over the burner while holding down the base of the wick with your thumb and forefinger.
3. Use your index finger to pull the rest of the wick away from the burner.
4. Cut the wick again when you’ve about 1/4 inch left. Repeat Steps 3 & 4 until you’ve trimmed the entire wick.

Grab the lighter

Grab a pillar candle and place it inside a holder. Set it down on the table or a flat surface and make sure to keep it away from anything hot, like a stovetop. This is to make sure that the candle does not go out quickly due to the flame being near something hot.

Now grab a candle lighter and hold it over the candle. Gently blow across the lighter until the candle slowly starts to catch fire. Do this until the wick is on fire and then remove the lighter. Once the candle is lit, place it away from flammable objects like curtains, bedsheets, or pillows. Also make sure the flame is not flickering as it causes the candle from not burning evenly. Therefore, make sure the flame is away from fans or open windows to avoid flickering.

Always ensure that the top layer of the candle is completely melted before extinguishing the flame. This is to make sure that the candle burns evenly on the next burn and does not produce a tunneling. And that is how you light a candle with a candle lighter.

Make the best out of wax

It is important to know how much of the candle you can burn before you need to stop using the candle. Make sure the pillar candles only reach one inch high. This step is very important because burning the candle for any less than an inch could cause a fire hazard. Therefore, to not waste the remaining wax, you can reuse it.

You can use a tray to collect the melted wax for the best results. You can easily find these trays at most hardware stores. They come in different sizes and shapes.

To start off:

1. Pour some melted wax into a glass container.
2. Place the container onto a heatproof surface, like a metal baking sheet.
3. Set your timer for 10 minutes, and wait patiently.
4. Once the wax reaches about half an inch in height, turn off the burner.

Now, take a butter knife and gently scrape away the sides of the glass container. Don’t worry if there are bits of wax left behind; just clean everything out.

When the wax is completely solidified, carefully pick up the container and place it on a flat surface. Now, let the candle cool for another three hours.

Is there any safety concern about the container?

Of course, there is! No matter what you do, there is always some safety concern around it. Here are a few things to do. So that you don’t burn your whole home:

• Keep the candle’s wick trimmed so that there isn’t too much excess material. Suppose there is any kind of debris inside the glass jar, including dirt, hair, or pieces of wick or match. In that case, they could be flammable and could lead to the candle burning too hot for its container.
• Use neoplastic containers, which won’t break if they get hot. Also, be careful when using glasses because they could crack. Hot wax can be released from inappropriate container types. If the flame isn’t contained within a vessel, there’s an increased chance of fire.
• To prevent the container from catching fire and damaging nearby objects, cut off the wicks at least one-eighth of an inch before lighting them. A scissors-like device with a small cutting surface at its tip called a wick trimmer can be used to cut hair neatly each time. The small plate helps prevent the wick from sticking out too far so that you don’t need to touch the hot melted candles.
• If the wax in your candle becomes too thin, it won’t burn properly. To get an idea of how long a jar candle burns, use this simple formula: Stop lighting when a jar candle has hit ¼ of its total height. If a candle isn’t in a container, the maximum height for the candle is two inches above the base of the wick.

Things to keep in mind while handling candles

Make sure to place candles where they won’t be affected by heat, cold, draft, pets, or children. Avoid placing any kind of candle near curtains, under cabinets or furniture, or on the floor because they could cause fire hazards. When burning candlelight, follow these safe practices:

• Keep them close by so they’re easy to reach when needed
• Follow the directions provided by the manufacturers.
• Use them in a well-ventilat­ed room.
• Don’t let the flame get too close to the wick.
• To put out the fire, use a snuffing tool instead of water.
• Before leaving the house or going to bed, put out any burning candles.
• Keep them at least three inches apart.
• Never leave a lit candle unattended.
• Always extinguish candles after use.

How long should a new candle be burned?

If you want a nice-smelling and long-burning candle, you should allow the candle to burn for at least three-quarters of an hour before extinguishing it. If you don’t let the candle burn long enough the first time ( if you don’t allow the candle to fully set), then the candle may not be able to create a complete pool of melted paraffin at every new burn. Tunneling occurs when the wick burns straight through the middle of the candle without melting any paraffin. In the event that your wick tunnels, all that peripheral wax area is lost for future burning.

See Also: Can You Use A Flower Vase For Candle Holder?

Some mistakes people make with candles

• Blowing Out candles

When blow out a candle, it produces smoke which causes tiny black sooty particles to be created and spread throughout the candle. This makes the candle smell bad. You don’t need to buy a snuffing device. There is a simple way to stop a candle from burning; you put a lid on top of the flame. It works exactly the same as blowing the candle out, but it produces less smoke and the stops black sooty particles from being made. After that you should wait until the candle has cooled down completely before handling it.

• Not using enough wax

You need to have about half of the candle’s weight in wax. This will ensure that the candle burns evenly.

• Burning the candle too fast

The faster you burn the candle; the more likely the candle will explode. You should only burn the candle for about 10 minutes. After that, the candle will start to smell bad and become hard to handle.

• Using the wrong size candle

The best way to find the right size candle is to measure the diameter of the glass container. Then add one inch to that measurement. For example, if the glass container measures 8 inches, then you would add 1 inch to make 9 inches.

• Not allowing the candle to cool

A hot candle can melt the wax around the edges of the container. The melted wax will drip onto the table or other surfaces.

• Not cleaning up the mess

After you’ve finished burning the candle, clean up the mess immediately. Don’t forget to wipe off the sides of the container.

• Leaving the candle burning overnight

Candles are meant to be used during the day. They shouldn’t be left burning overnight. Candles produce carbon monoxide gas. Carbon monoxide is poisonous. If candles are left burning for too long, they may start to smoke or even explode. If you let a fire burn for too long, you might get a surprise visit from firefighters who come to put out the flames before they spread. As soon as a wick gets too long, it burns unevenly because there isn’t enough oxygen to support combustion. Wax-tunneled candles can cause soot buildup inside the container, which may eventually cause the container to crack.

See Also: Can You Use A Flower Vase For Candle Holder?

FAQs

Final Thoughts

The candle is an easy way to enhance the beauty of your home. It’s not that complicated to handle too. You just need to be careful while handling candles. After reading this, I can assure you that you know very well how to burn a candle without a jar, including how to handle a candle.